* 0W-20 (preferred for all temperatures)
* 5W-20 (acceptable for all temperatures)
* 10W-30 (acceptable for moderate climates)
Note: The owner's manual for your specific vehicle may recommend a different oil type or weight than what is listed here. Always refer to the owner's manual for the most accurate and up-to-date information.
How to Check Your Honda CR-V's Oil Level
1. Park your car on a level surface and turn off the engine.
2. Wait a few minutes for the oil to settle.
3. Open the hood and locate the oil dipstick. It is usually located near the front of the engine and has a yellow or orange handle.
4. Pull out the dipstick and wipe it clean with a paper towel.
5. Reinsert the dipstick into the oil dipstick tube until it is fully seated.
6. Pull out the dipstick again and check the oil level. The oil should be between the "Full" and "Add" marks on the dipstick.
7. If the oil level is low, add enough oil to bring it up to the "Full" mark.
How to Change Your Honda CR-V's Oil
Changing your oil is a relatively simple task that can be completed in about 30 minutes. Here are the steps involved:
1. Gather your materials. You will need:
* New oil (see above for the recommended type)
* A new oil filter (check your owner's manual for the correct size)
* An oil drain pan
* A funnel
* A wrench
* A rag
2. Prepare your car. Park your car on a level surface and turn off the engine. Wait a few minutes for the oil to settle. Engage the parking brake. If you can’t crawl under your car, you will need to raise it either with ramps and a chock or a jack and jack stands. (Never crawl under a car that is supported only by a jack.)
3. Locate the oil drain plug. It is usually located on the bottom of the oil pan.
4. Place the oil drain pan under the oil drain plug.
5. Loosen the oil drain plug with the wrench. Be careful not to drop the bolt into the oil pan.
6. Allow the oil to drain completely. This may take a few minutes.
7. Replace the oil drain plug. Tighten the plug until it is snug.
8. Locate the oil filter. It is usually located near the top of the engine.
9. Remove the oil filter with the wrench. Be careful not to spill any oil.
10. Apply a thin coat of new oil to the gasket of the new oil filter.
11. Screw on the new oil filter until it is snug. Do not overtighten the oil filter.
12. Add new oil to the engine. Use the funnel to add oil to the engine until the oil level is between the "Full" and "Add" marks on the dipstick.
13. Start the engine and let it run for a few minutes.
14. Check the oil level again and add more oil if necessary.
15. Dispose of the old oil and oil filter properly.
Tips for Changing Your Honda CR-V's Oil
* Make sure to use the correct type and weight of oil for your engine.
* Check the oil level regularly and add oil as needed.
* Change the oil and oil filter at the recommended intervals.
* If you have any questions about how to change your oil, consult your owner's manual or a qualified mechanic.
