Auto >> AutoSPT >  >> Auto Repair

How to adjust rear shocks on Kawasaki Vulcan 1500 classic 1997?

To adjust the rear shocks on your Kawasaki Vulcan 1500 Classic 1997, follow these steps:

1. Park your motorcycle on a level surface and turn off the engine.

2. Locate the rear shock absorbers. They are located on either side of the rear wheel, just below the seat.

3. Locate the adjustment knob on the top of each shock absorber.

4. Use the wrench to turn the adjustment knob clockwise to increase the preload on the shock absorber, or counterclockwise to decrease the preload.

5. Continue turning the adjustment knob until you reach the desired preload setting. The recommended preload setting for the Kawasaki Vulcan 1500 Classic 1997 is 25mm of sag

6. Test ride your motorcycle to ensure that the shocks are set to your liking.

Auto Repair
How To Replace A Bad Thermostat In Your Car How do you install rear brake pads and caliper on a 94 Honda Accord?
Car Care
Where can a company look when trying to repo your car? Rolls Royce – A Car with Class How to Turn Off a Car: The Systematical Way
Engine
94 dodge ram with 318 when on going down the road oil pressure is about 30 to 35 in 5th gear at 50mph i let off gas it goes up 45 50 psi new pump as been installed? Where is the glow plug relay located on a volkswagon jetta diesel?
Electric Car
Where is the schrader valve on a 1994 Toyota Camry? Change spark plug wires 1982 Corvette? How do you remove the steering wheel on a 1979 Chevy Silverado stepside pick up?
Autopilot
What does a motorbike do? Where is the crank position sensor located on a C280 Mercedes and what needs to be removed gain access change it?
Car Photos
Where is the choke on a 1995 Chevrolet Blazer? What is a fog light on car for? What is the rear track of 2014 Mazda CX-9?