* Soldering iron
* Solder
* Flux
* Desoldering braid
* Replacement display unit
* Small flat-head screwdriver
* Phillips-head screwdriver
Instructions:
1. Power off the vehicle and disconnect the battery.
2. Remove the instrument cluster by removing the screws that hold it in place.
3. Disconnect the electrical connectors from the back of the instrument cluster.
4. Use a small flat-head screwdriver to pry open the plastic housing of the instrument cluster.
5. Carefully remove the old display unit from the housing.
6. Clean the contacts on the circuit board with a cotton swab and isopropyl alcohol.
7. Apply a thin layer of flux to the contacts.
8. Solder the new display unit to the circuit board.
9. Use desoldering braid to remove any excess solder.
10. Reassemble the instrument cluster and reinstall it in the vehicle.
11. Reconnect the battery and power on the vehicle.
12. Test the multi function display to make sure that it is working properly.
