Auto >> AutoSPT >  >> Auto Repair

How do you replace the slave cylinder on a 1999 S-10?

1. Park your truck in a level area and apply the parking brake.

2. Disconnect the hydraulic line from the slave cylinder.

3. Remove the slave cylinder mount from the transmission bell housing.

4. Using a slide hammer or an appropriate puller, remove the slave cylinder from the transmission bell housing.

5. Remove the rubber boot from the end of the slave cylinder.

6. Clean the slave cylinder body and the bore of the transmission bell housing.

7. Install a new rubber boot on the end of the slave cylinder.

8. Using a new O-ring, install the slave cylinder into the transmission bell housing.

9. Secure the slave cylinder mount to the transmission bell housing.

10. Reconnect the hydraulic line to the slave cylinder.

11. Bleed the hydraulic system to remove any air.

Auto Repair
How can you tell if need new brakes? How do i replace the passenger rear vent window motor on a 1999 chrysher town and country lxi minivan?
Car Care
How Much Transmission Fluid Do I Need In My Car? If I do not have a car in my name with insurance will SR22 cover that. an card but on it is name. The am driving does coverage.? Keep your car running and your social distance
Engine
How Engine Detonation occures? What is the top speed of a 2009 Ford Mustang?
Electric Car
How do you reset warning lights on a Pontiac G6 GT? How do you replace the spark plugs on a 1996-2000 Dodge Caravan or Chrysler Town and Country? What is the Spark plug setting for 2001 Lincoln town car?
Autopilot
How to advance timing on a 50cc gy6 scooter motor? Where is crank sensor on v6 2004 Kia Optima?
Car Photos
What does an amber tap light mean on a car dash? What could cause a car to sputter and eventually backfire at high rpms only in 3rd 4th 5th gear but not 1st or 2nd? How do you remove the sunroof for 1988 Porsche 944?