1. A socket set with an extension
2. A ratchet
3. A spark plug wrench
4. New spark plugs
Here is a step-by-step guide:
1. Jack up the car. Ensure that your vehicle is parked on a level surface, engage the parking brake, and chock the wheels that will remain on the ground.
2. Open the hood and remove the engine cover.
3. Remove the engine cover by unclipping the plastic clips and lifting it off the engine.
4. Locate the spark plugs. The spark plugs are located on the top of the engine.
5. Remove the spark plug wires by pulling on the boot. You can use a spark plug boot puller tool or carefully pull them by hand.
6. Remove the old spark plugs by using a spark plug wrench.
7. Gap the new spark plugs. Use a spark plug gapper tool and adjust the plug gaps to the recommended specifications.
8. Install the new spark plugs by hand until they are finger-tight.
9. Tighten the spark plugs using a spark plug wrench.
10. Reconnect the spark plug wires.
11. Replace the engine cover and lower the vehicle. Start the engine and check that it is running smoothly.
