Here are the steps:
1. Park your car in a safe location and turn off the engine.
2. Open the trunk of your car.
3. Locate the brake light assembly. It is located on the rear of the car, on either side of the trunk lid.
4. Remove the two screws that hold the brake light assembly in place.
5. Disconnect the electrical connector from the back of the brake light assembly.
6. Remove the old brake light bulb from the assembly.
7. Insert the new brake light bulb into the assembly.
8. Reconnect the electrical connector to the back of the brake light assembly.
9. Replace the two screws that hold the brake light assembly in place.
10. Test the brake lights to make sure they are working properly.
Here are some additional tips for replacing brake lights:
* Be sure to replace the brake lights with the same type and size of bulb that was originally installed.
* If the brake lights are not working properly after you replace them, check the fuses and the wiring.
* If you are uncomfortable replacing the brake lights yourself, you can take your car to a mechanic and they will do it for you.
Replacing your car's brake lights is an important safety measure. By following these steps, you can ensure that you can safely see and be seen while driving.