1. Check the Recoil Spring:
- Open the recoil housing using the appropriate tool, often a screwdriver or a wrench.
- Inspect the recoil spring for damage, fraying, or deformation. If the spring appears damaged or stretched, it needs to be replaced.
2. Re-Position the Pull Cord:
- If the recoil spring is intact, reposition the pull cord correctly around the pulley. Make sure the cord is seated properly in the slot or groove on the pulley.
3. Wind the Pull Cord:
- Hold the end of the pull cord firmly and slowly pull it out until the recoil spring is fully tensioned.
- Release the pull cord and allow it to retract fully.
4. Check Cord Length:
- Ensure the pull cord is long enough to start the mower comfortably. If it's too long, trim the excess cord. If it's too short, replace the cord.
5. Test the Pull Cord:
- Replace the recoil housing cover, and attempt to start the mower using the pull cord. If the cord retracts again, ensure the retainer that holds the cord in place is functional and not broken.
6. Consult the Manual:
- If you're unsure about any of these steps or encounter issues, refer to your mower's user manual or contact the manufacturer for specific instructions and troubleshooting tips.
Remember, if the recoil spring needs replacing or the retainer is broken, it's essential to use genuine replacement parts recommended by your mower's manufacturer to ensure proper fit, performance, and safety.
