Required tools and materials:
- Pliers
- Screwdriver
- New overflow tank (if necessary)
Procedure:
1. Park the vehicle on a level surface and apply the parking brake.
Ensure the engine is cool to prevent burns.
2. Locate the overflow tank.
The overflow tank is typically located in the engine bay on the passenger side near the radiator.
3. Disconnect any electrical connections.
If there are any electrical connections attached to the overflow tank, disconnect them by pressing down on the release tab and pulling the connector straight off.
4. Remove the overflow tank cap.
Unscrew the overflow tank cap by turning it counterclockwise.
5. Remove the hoses from the overflow tank.
There will be two hoses connected to the overflow tank. Use a pair of pliers to squeeze the spring clamps on the hose ends and pull the hoses off the tank.
6. Remove the overflow tank mounting bolts.
Locate the bolts securing the overflow tank to the vehicle's body. Use a screwdriver to loosen the bolts, and then remove them by hand.
7. Remove the overflow tank.
Once the bolts are removed, you can lift the overflow tank out of the engine bay.
8. Clean any spills or debris.
Before installing a new overflow tank, be sure to clean any spills or debris from the area.
9. Install a new overflow tank (if necessary).
If you are installing a new overflow tank, reverse the steps above to put it in place.
10. Reconnect any electrical connections.
If there were any electrical connections attached to the old overflow tank, reconnect them now.
11. Fill the overflow tank with coolant.
Open the radiator cap and slowly pour coolant into the overflow tank until the tank is about half full.
12. Close the overflow tank cap and start the engine.
Let the engine run for a few minutes to circulate the coolant through the system.
Note: When the vehicle is running, the coolant level in the overflow tank may fluctuate. This is normal as long as the level remains between the "MIN" and "MAX" marks on the tank.
