1. Park your vehicle in a safe location and turn off the engine.
2. Open the trunk of your vehicle.
3. Locate the access panel for the rear turn signal bulb.
The access panel is located on the inside of the trunk, behind the carpet.
4. Remove the access panel.
The access panel is held in place by a few screws. Use a screwdriver to remove the screws and then remove the access panel.
5. Locate the turn signal bulb.
The turn signal bulb is located inside the access panel. It is a small, round bulb with a metal base.
6. Remove the turn signal bulb.
To remove the turn signal bulb, simply twist it counterclockwise and pull it out of its socket.
7. Install the new turn signal bulb.
To install the new turn signal bulb, simply push it into the socket and twist it clockwise until it is secure.
8. Replace the access panel.
Replace the access panel by inserting the screws and tightening them until the panel is secure.
9. Close the trunk of your vehicle.
10. Turn on the turn signal to test the bulb.
The new turn signal bulb should now be working properly.
